Starting Windows 2000 in Safe Mode

Starting Windows 2000 in Safe Mode

To start Windows 2000 in safe mode

  1. Click Print this page at the bottom of this window, and then click Print to print these instructions. They will not be available to you after you shut your computer down in the following steps.
  2. Click Start, and then click Shut Down.
  3. Click Restart, and then click OK.
  4. When you see the message Please select the operating system to start, press F8.
  5. Use the arrow keys to highlight the appropriate safe mode option, and then press ENTER.

    Note: NUM LOCK must be off before the arrow keys on the numeric keypad will function.

  6. Use the arrow keys to highlight an operating system, and then press ENTER.

Note:

  • In safe mode, Windows 2000 uses only basic files and drivers (mouse, monitor, keyboard, mass storage, base video, default system services, and no network connections). You can choose the Safe Mode with Networking option, which loads all of the above files and drivers plus the essential services and drivers to start networking, or the Safe Mode with Command Prompt option, which is exactly the same as safe mode except that a command prompt is started instead of Windows 2000. You can also choose Last Known Good Configuration, which starts your computer using the registry information that Windows 2000 saved at the last shutdown.
  • Safe mode helps you diagnose problems. If a symptom does not reappear when you start in safe mode, you can eliminate the default settings and minimum device drivers as possible causes. If a newly added device or a changed driver is causing problems, you can use safe mode to remove the device or reverse the change.
  • There are circumstances where safe mode will not be able to help you, such as when Windows system files required to start the system are corrupted or damaged. In this case, the Emergency Repair Disk (ERD) may be helpful.

To start your computer at a command prompt

  1. Click Start, and then click Shut Down.
  2. Click Restart, and then click OK.
  3. When you see the message Please select the operating system to start, press F8.
  4. Use the arrow keys to highlight Safe Mode with Command Prompt, and then press ENTER.

    NUM LOCK must be off before the arrow keys on the numeric keypad will function.

  5. Use the arrow keys to highlight an operating system, and then press ENTER.

To start Windows 2000 using the last known good configuration

  1. Click Start, and then click Shut Down.
  2. Click Restart, and then click OK.
  3. When you see the message Please select the operating system to start, press F8.
  4. Use the arrow keys to highlight Last Known Good Configuration, and then press ENTER.

    NUM LOCK must be off before the arrow keys on the numeric keypad will function.

  5. Use the arrow keys to highlight an operating system, and then press ENTER.

Note:

  • Choosing Last Known Good Configuration provides a way to recover from problems such as a newly added driver that may be incorrect for your hardware. It does not solve problems caused by corrupted or missing drivers or files.
  • When you choose Last Known Good Configuration, Windows 2000 restores information in registry key HKLM\System\CurrentControlSet only. Any changes you have made in other registry keys remain.

Notice: Windows® 95, Windows® 98, Windows® NT, Windows® 2000 and
Microsoft® Office are registered trademarks or trademarks of the Microsoft Corporation.

About Dewwa Socc

Sahifa Theme License is not validated, Go to the theme options page to validate the license, You need a single license for each domain name.